ПСРкН FRHF FE180/Eк30 (J-HXH-FE180) Communication and alarm wires, fire resistant

Stability during single burning

Stability when burning in a bundle

Halogen-free

FIELD OF APPLICATION

Alarm systems, access control systems, control, monitoring, communication and telecommunication systems, with increased requirements for their fire resistance
For the transmission of low-power electrical signals
For installation of station equipment, for stationary installation inside buildings, structures, in dry and wet areas, areas with a high concentration of people

ADVANTAGES

Preservation of circuit integrity, under standard temperature conditions, from 30 to 90 minutes at temperatures from ~842˚C (Ek30) to ~1006˚C (Ek90)
It does not emit corrosive gaseous products in case of fire. gaseous products, prevents possible damage to electronic equipment
The wires are tested for laying outside the hermetic zone in cable structures and NPP premises in systems of classes: 2, 3, 4 according to the classification of NP 306.2.141-2008

CONSTRUCTION

Resin	Copper conductors, in accordance with the requirements of DSTU EN 60228, flexibility class 1
Insulation	Organosilicon rubber
Outer shell	Halogen-free composition in orange color
Number of cores	2, 4, 6, 8, 10, 12÷61

TECHNICAL CHARACTERISTICS

Electrical resistance depending on the nominal diameter of the core, not more than:

mm
Ohm/km

0,4
160

0,5
110

0,8
36

1,05
24,5

1,13
18,1

1,38
12,1

1,78
7,41


Temperature range	-30˚С to +70˚С
Test voltage	1000 W
Operating voltage	300 W
Electrical resistance of insulation	100 megohms/km
Minimum bending radius	10 х D
Color identification of cores	DSTU IEC 60304

COMPLIANCE / STANDARDS

Single combustion - clause 4.1 of DSTU 4809, DSTU EN 60332-1 -2Single combustion - clause 4.1 of DSTU 4809, DSTU EN 60332-1 -2

Combustion in bundles - clause 4.2 of DSTU 4809, DSTU EN 60332-3-22

Toxicity - p. 4.3 DSTU 4809.

Smoke smoke - clause 4.4 of DSTU 4809.

Combustion smoke - clause 4.5 of DSTU 4809, DSTU EN 61034-2.

Halogens and corrosivity - clause 4.6 of DSTU 4809, DSTU EN 60754-2.

Standard temperature conditions (clause 4.7 of DSTU 4809).

Integrity of circuits under conditions of exposure to flame with a temperature of at least 750˚C - 4.8 DSTU 4809, DSTU IEC 60331-. 23.

TABLE OF NOMENCLATURES

Article no.	Number of cores and cross section mm2	Maximum outer diameter	Mass of copper	Mass.
10100401	2х0,4	4.3	2.3	14
10100402	4х0,4	5.6	4.61	22
10100403	6х0,4	6.0	6.91	32
10100404	8х0,4	7.3	9.22	39
10100405	10х0,4	7.8	11.52	47
10100406	12х0,4	8.0	13.82	57
10100407	2х0,5	4.5	3.6	18
10100408	4х0,5	6.1	7.2	28
10100409	6х0,5	6.5	10.8	41
10100410	8х0,5	7.8	14.4	51
10100411	10х0,5	8.3	18	62
10100412	12х0,5	8.5	21.6	75
10100413	2х0,8	6.1	9.22	34
10100414	4х0,8	7.8	18.43	53
10100415	6х0,8	8.5	27.65	76
10100416	8х0,8	10.1	36.86	95
10100417	10х0,8	10.8	46.08	118
10100418	12х0,8	11	55.29	141
10100419	2х1,05	6.8	15.88	45
10100420	4х1,05	8.6	31.75	73
10100421	6х1,05	9.4	47.63	106
10100422	8х1,05	11.3	63.5	134
10100423	10х1,05	12.0	79.38	166
10100424	12х1,05	12.4	95.25	201
10100425	2х1,13	7.27	18.39	51
10100426	4х1,13	8.4	36.77	85
10100427	6х1,13	10.15	55.16	122
10100428	8х1,13	10.99	73.55	154
10100429	10х1,13	13.04	91.93	194
10100430	12х1,13	13.69	110.32	231
10100431	2х1,38	8.1	27.42	67
10100432	4х1,38	9.38	54.84	112
10100433	6х1,38	11.34	82.27	162
10100434	8х1,38	12.28	109.69	207
10100435	10х1,38	14.58	137.11	259
10100436	12х1,38	15.28	164.53	309
10100437	2х1,78	9.36	45.62	96
10100438	4х1,78	10.88	91.25	165
10100439	6х1,78	13.18	136.87	239
10100440	8х1,78	14.29	182.49	307
10100441	10х1,78	17.00	228.12	385
10100442	12х1,78	17.78	273.74	458