Аlay-net F/UTP FR Cat 5 Network cable, shielded, twisted pair, fire resistant

Stability during single burning

Stability when burning in a bundle

Halogen-free

Resistant to electrical influences-shielded

FIELD OF APPLICATION

At facilities with increased fire protection requirements
For construction of structured cable systems
Data transfer at speeds up to 100 Mbps
ISDN, Ethernet (10Base-T), ATM-25/52/155 Mbit/s, 100VG-AnyLAN, Fast Ethernet (100BASE-TX), Token Ring 16/100 Mbit/s, Firewire 100 Mbit/s, PoE (IEEE 802.3af), PoE+ (IEEE 802.3at), PoE++ (IEEE 802.3bt), HDBaseT, 1000BASE-T

ADVANTAGES

The cables are tested for installation outside the hermetic zone in cable structures and NPP premises in systems of classes: 2, 3, 4 according to the classification of NP 306.2.141-2008
Preservation of circuit integrity, under standard temperature conditions for 30 minutes at temperatures from ~842˚C (Ek30)
Data transmission in fire conditions up to 30 minutes
Shields protect against interference and ensure reliable signal transmission

CONSTRUCTION

Resin	Copper conductors, in accordance with the requirements of DSTU EN 60228, flexibility class 1
Insulation	Organosilicon rubber
Outer shell	Halogen-free composition in orange color
Number of cores	2х2, 4х2
Screen	Synthetic film foiled with aluminum + grounding conductor

TECHNICAL CHARACTERISTICS

Electrical resistance depending on the nominal diameter of the core, not more than:

mm
Ohm/km

0,51 (24 AWG)
96

Temperature range

-10˚C to +70˚C

Test voltage

2500 W

Operating voltage

72 W

Electrical resistance of insulation

5 Gohm/km

Minimum bending radius

10 х D

Color identification of cores

DSTU IEC 61156-1

Signal transmission characteristics

Frequency, MHz	1	4	10	16	20	31,25	62,5	100
Fading	2,1	4,1	6,5	8,3	9,3	11,7	17	22

Electrical capacity

56 pF/m

Wave impedance in the frequency range of 1-100 MHz

100±15 Ом

COMPLIANCE / STANDARDS

DSTU ISO/IEC 11801

DSTU IEC 61156-2

Single combustion - clause 4.1 of DSTU 4809, DSTU EN 60332-1 -2

Combustion in bundles - clause 4.2 of DSTU 4809, DSTU EN 60332-3-22

Smoke smoke - clause 4.4 of DSTU 4809

Combustion smoke - clause 4.5 of DSTU 4809, DSTU EN 61034-2.

Halogens and corrosivity - clause 4.6 of DSTU 4809, DSTU EN 60754-2.

Standard temperature conditions (clause 4.7 of DSTU 4809).

Integrity of circuits under conditions of exposure to flame, the temperature of which is not less than 750 ° C of which is not less than 750 ° C - 4.8 DSTU 4809, DSTU IEC 60331-23

TABLE OF NOMENCLATURES

Article no.	Number of cores and cross section mm2	Maximum outer diameter	Mass of copper	Mass.
10201101	2х2х0,51	8,4	8,53	48
10201102	4х2х0,51	9,8	15,94	71